Brand New Full Glue Tempered GlassAll toughened glass on the market can not be fully adhesive, resulting in touch insensitive, in order to solve this problem, we have been committed to the development of full glue glass, and now has completed this product.
Unique Nano Water
Through the nano water drops on the phone surface, and then completely filled with glue screen, to achieve full glue adhesive.
With 6d tempered glass, making tempered glass can perfectly cover the curvature of the phone, glue until all full screen.
Give away a UV light, after the glue completely covers the screen, then just uv light each irradiation for 2 minutes till the nano water freeze. For other questions, you can contact us.
Full glue tempered glass compared to market tempered glass touch more sensitive, For other questions, you can contact us.
How to install this protector
1. Use a foil cleaning kit to wipe the phone to be clean.
2 .Place the sticker over the hole in the handset. Stick the key hole with a label.
3 .Place custom glue drops on flat, clean and dust-free glass screens. Use each glue to use. It is recommended that the glue be poured completely. The excess glue can be wiped clean before turning on the lights. The glue can only be a mass and cannot be separated. Drops on the screen.
4 .The glue that drops on the screen can’t have air bubbles, if there is air bubble, use the needle to pierce the air bubble to let go air.
5 .Remove the release film from the protective film and place the glass on the screen so that the glass contacts the glue and gently translate the glass to a suitable position. Do not lift the glass and allow the glass to separate from the glue (very important).
6 .Wait for about 30 seconds to let the glue slowly spread and level.
7. There is glue overflow, wipe off with a clean cloth. After checking the retention criteria for the mobile phone’s tempered film, the lamp was turned back and forth three times around the edge of the phone, and after 3 seconds of initial curing (not in the middle), the edge glue was wiped again until the glue overflowed. (Prevent white edges or long bubbles on edges)
8. Wait for the exhaust to complete, after the glue overflows cleanly, after the positioning standard of the tempered film is satisfied, turn on the light. Otherwise scrapped material.
9. Irradiate the mobile phone under UV light and need to illuminate twice for about 3 minutes to reach the fully-cured position.